.webp){kind=small}
Installation Guide
Learn how to properly install and position your VitaTemp sensors for optimal performance and accurate temperature monitoring.
Installation Process
1
Create an Account on LST Vita
Download the app and set up your monitoring account
- Go to app store and download LST Vita App
- If you don't have an account click 'Sign-up'
- Create your account and follow the setup instructions
2
Gateway Installation
Set up your LoRaWAN gateway for data transmission
- Choose a central location relative to all sensors
- Attach the antenna, Ethernet cable, and power cable
- Connect the Ethernet cable to your router
- Power on the Gateway
- Confirm the three indicator lights are on: Ethernet, Power, and LoRa
3
Sensor Installation
Activate and install your temperature sensors
- Press and hold the 'ACT' button on the front of the sensor to power it on. Once it starts blinking (about 3 seconds), you can release
- Click the 'Add Sensor' to add your temperature sensors in the app
- Mount the sensor inside the refrigerator
- Ensure the sensor is securely mounted
4
Configure Alerts
Set up temperature and humidity alert thresholds
- Open the LST Vita app and select your sensor
- Set minimum and maximum temperature limits per sensor
- Configure humidity alerts if needed
- Enable notifications under Settings > Notifications > General Notifications
- Test alerts by temporarily adjusting thresholds
Optional: Probe Installation (For Weak Signal)
3b
Probe Installation
Use the probe when the sensor signal is weak or when you need to mount the sensor outside the refrigerator.
- Attach the probe to the sensor
- Mount the probe inside the refrigerator
- Mount the sensor outside the refrigerator
- Enable the probe in the app (note: this will disable humidity readings)
To Enable Probe in App:
- Select Temperature Sensor
- Select the pencil in the top right corner
- Scroll to the bottom and enable the probe
Placement Guidelines
Temperature Accuracy
Do
- •Place away from direct sunlight
- •Avoid heat sources (ovens, heaters, lights)
- •Mount at representative height (4-6 feet)
- •Ensure good air circulation
Don't
- •Don't place near windows
- •Avoid drafty areas
- •Don't mount on exterior walls
- •Avoid areas with temperature fluctuations
Signal Strength
Do
- •Maintain line of sight to gateway when possible
- •Keep within 2,000 feet of gateway
- •Mount higher for better signal
- •Test signal strength before final placement
Don't
- •Don't place behind metal objects
- •Avoid thick concrete walls
- •Don't place in metal enclosures
- •Avoid areas with RF interference
Environmental Protection
Do
- •Use in dry, indoor environments
- •Protect from moisture and condensation
- •Ensure stable mounting surface
- •Keep away from chemicals
Don't
- •Don't expose to water or rain
- •Avoid high humidity areas without protection
- •Don't place where it can be knocked over
- •Avoid corrosive environments
Environment-Specific Guidelines
Walk-in Coolers
Target Range: 35-38°F
- Mount away from door and evaporator
- Protect from condensation
- Consider multiple sensors for large units
Freezers
Target Range: 0 to -10°F
- Use cold-rated batteries
- Allow for longer transmission intervals
- Mount away from defrost cycles
Dry Storage
Target Range: 50-70°F
- Monitor both temperature and humidity
- Place away from loading docks
- Consider seasonal temperature changes
Pharmaceutical Storage
Target Range: 68-77°F
- Follow USP guidelines
- Document sensor calibration
- Use multiple sensors for redundancy
Maintenance & Battery Replacement
Regular Maintenance
- Check battery level monthly in the app
- Clean sensor housing quarterly
- Verify alert settings are current
- Test alerts periodically
Battery Replacement
- Replace when battery shows 20% or less
- Use high-quality lithium batteries
- Sensor will resume automatically after replacement
- Expected battery life: 10 years
Need Installation Help?
Our technical support team is here to help with your installation questions.